Configuration
The configuration assistant goes further than the setup wizard and helps you to configure a communication
system in sequence, from scratch. Logging on as administrator in WebAdmin (expert or default mode)
allows you to display the configuration assistant on the WebAdmin start page.
The configuration assistant comprises the following steps:
1. Viewing the IP addressing
2. Regulating access control
3. Checking licences
4. Configuring media resources
5. Setting date
6. Checking network interfaces
7. Setting up SIP providers and accounts
8. Specifying user permissions
9. Create users and DDI
1
numbers
10. Checking outgoing routing
11. Setting up the auto attendant
12. Setting up music on hold
13. Setting up an announcement service
14. Entering abbreviated dialling contacts
15. Saving configuration data
For each step, the upper half of the screen displays the configuration overview; the right-hand side
contains notes and instructions about the step you have selected. The WebAdmin online help can be
called up for further help.
You can skip individual configuration assistant steps or call up additional views of the WebAdmin
navigation tree. To hide the configuration assistant again, untick the control box on the WebAdmin start
page.
5.8 WebAdmin Configuration Notes
The sections below contain information that may be useful before, during or after a configuration with
WebAdmin.
5.8.1 Licences
All the features (even those subject to licences) can be configured without a valid licence.
If you use a function or feature that requires a licence but do not actually have the relevant licence, a
trial licence is acquired automatically; it is also shown in the overview of activated licences. With a trial
licence you can now use the function or feature free of charge for 60 days. The trial licence’s expiry date is
indicated under Status. This procedure can only be used once for each function or feature. Thereafter you
must acquire a licence. The licence overview (#unique_183) shows which trial licences are available.
Release 7.1
187 System Manual for Mitel SMB Controller
To Next Page
Loading...
Need help?
General
