Mitsubishi Electric a2 Series - Page 66

α 2 Simple Application Controllers
Function Blocks 6
6 - 12
Setup of the Pulse Function Block directly from the
α
2 Series Controller
1 ) Allocate the input pin to be used for the function block.
2 ) Press the “OK” key with the cursor in the function block. The function block edit screen is
displayed as shown.
3 ) Select Setup FB using the “ and ” keys and press the “OK” key. Select using the “
and ” keys the initiation type for the pulse operation.
4 ) Press the “OK” key to return to the function block edit screen.
Se t up FB
Change No
De l e t e FB
B001 :PL
RiseEdg
Fa l lEdge
Bo t hEdge
B001 :PL
e