9 TROUBLESHOOTING
9.1 CC-Link IE Field Network Basic Diagnostics
43
9
9 TROUBLESHOOTING
This chapter describes troubleshooting of CC-Link IE Field Network Basic.
9.1 CC-Link IE Field Network Basic Diagnostics
Perform troubleshooting by executing the CC-Link IE Field Network Basic diagnostics and checking the network status and
error details.
When the C Controller module is used, refer to the following.
MELSEC iQ-R C Controller Module User's Manual (Application)
How to execute diagnostics
Execute the CC-Link IE Field Network Basic diagnostics, following the procedure below.
1. Connect GX Works3/GX Works2 to the CPU module on the master station.
2. Start the CC-Link IE Field Network Basic diagnostics.
[Diagnostics] [CC-Link IEF Basic Diagnostics]
Diagnostic window
The status of the master station is checked in "Master Station Status".
The network status including slave stations is checked in "Network Status".
To Next Page
Loading...
