Mitsubishi Electric CR800 Series - Power Reset of Robot Controller After Restore

93
14.4. Power Reset of the Robot Controller
To make the restored information effective, it is necessary to power on the robot controller again.
If connecting to the CR800-D/CR750-D/CR751-D/CRnD-700 series controller, the power reset of the robot
controller can be performed from the T/B.
If connecting to the CR800-R/CR800-Q/CR750-Q/CR751-Q/CRnQ-700 series controller, please reset the
power by switch of the robot controller.
After restoring, the power reset conformation screen appears. To immediately reset the power, select [Yes].