107
[Load] / [Save] / [Delete signal file in robot]
The edited result can be saved on or loaded to a personal computer or robot controller. Specify the save
destination / load destination and tap the [OK] button. If the save destination is a personal computer, a file name
can be specified. However, if the save destination is a robot controller, the result will be overwritten on the previous
information.
The file can be deleted with the [Delete signal file in robot] button. (<f>)
15.3.2.3. Stop signal
The state of the stop signal (stop, emergency stop) input into the robot controller can be referred to.
If the I/O signal name is not displayed, update the parameter list
from the parameter edit screen and restart the T/B.
To Next Page
Loading...
