180
17.4.25. I/O unit
You can set information related to the I/O unit of the PLC.
Set parameters while connected to the robot controller.
This function can be used with Version 3.0 or later of this software. Moreover, the software version of the
controller which can use this parameter is as follows.
S/W Ver. of the controller
CR750-D/CRnD-700/ CR800-D
Can be used with all versions
When a unit number in [Unit #] is specified, the parameter of the specified unit number is displayed in the PLC
I/O unit.
In the [IO sharing when using Multiple CPUs], it is set up whether XY signals read or they don’t read
After you change the parameter values, you can rewrite the parameters in the robot controller by tapping the
[Write] button.
To Next Page
Loading...
