Mitsubishi Electric CR800 Series - Displaying and Configuring Messages

216
19.1.5.9. Message
Set the message when message is displayed by the state of the I/O signal.
(1) Select [Message] button (<a>). When [Message] button is not displayed there, please tap [Line] button.
(2) After "Message list" window is displayed, select [Add] button (<b>).
(3) After "Message editor" window is displayed, set [Message] and [Displaying condition], etc. Tap [OK] button
(<d>).
Select [Edit] button (<c>) , and message can be edited.
<a>
<b>
<c>
<d>
<3>
<1>
<2>
<4>
<5>
<6>
<7>