Mitsubishi Electric CR800 Series - 20 Operation Panel; Starting

235
20. Operation panel
The Operation panel is a screen prepared for the controller with whom the operation panel is not equipped. This
screen has functions equal with controller's operation panel. This screen can be started by selecting the program.
This screen is possible to use it even in "AUTOMATIC" and "MANUAL" mode.
Operation panel is not displayed with the software before version 3.0. Moreover, the software version of the
controller which can use this function is as follows.
Controller
S/W Ver. of the controller
CR750-D/CRnD-700
Ver.S3 or later
CR750-Q/CRnQ-700
Ver.R3 or later
CR800-D/R/Q
Can be used with all versions
20.1. Starting
(1) Tap the [MENU] button (<a>) of a T/B screen and display menu panel.
(2) Tap the [Operation panel] button (<b>) in the menu.
(3) The Operation panel screen is displayed.
(4) T/B Enable lamp (<c>) blinks at the "AUTOMATIC" mode.
Even if the operation screen is displayed, sheet key (<d>) can be used so far.
<a>
<b>
<c>
<d>
<d>
<d>