Mitsubishi Electric CR800 Series - Program Select; Override UP;DOWN

237
20.3. Program select
The robot program can be selected at slot 1.
(1) Tap the [Select] button (<a>).
(2) [Select] dialog (<b>) is displayed.
(3) Select the program and Tap the [Select] button (<c>)
(4) Since the confirmation screen is displayed, the [Yes] button (<e>) is tapped.
Note) The program selection cannot be done while executing the program.
20.4. Override UP/DOWN
Override is lowered with [DOWN] button (<a>) , and it raises it with [UP] button (<b>).
Upper and lower width in the operation panel screen is ten. Please note that upper and lower width is different with
[↑] and [↓] of the sheet key of T/B.
<a>
<b>
<a
<b>
<c>
<d>
<e>