Mitsubishi Electric EZMOTION MR-E Super MR-E-70A-QW003 - Page 89

5 - 4
5. PARAMETERS
No. Symbol Name
Control
mode
Initial
value
Unit
Customer
setting
50 For manufacturer setting 0000
51 *OP6 Function selection 6 P S 0000
52 For manufacturer setting 0000
53 *OP8 Function selection 8 P S 0000
54 *OP9 Function selection 9 P S 0000
55 *OPA Function selection A P 0000
56 SIC Serial communication time-out selection P S 0 s
57 For manufacturer setting 10
58 NH1 Machine resonance suppression filter 1 P S 0000
59 NH2 Machine resonance suppression filter 2 P S 0000
60 LPF Low-pass filter/adaptive vibration suppression control P S 0000
61 GD2B Ratio of load inertia moment to Servo motor inertia moment 2 P S 70
Multiplier
(
10
1
)
62 PG2B Position control gain 2 changing ratio P 100
63 VG2B Speed control gain 2 changing ratio P S 100
64 VICB Speed integral compensation changing ratio P S 100
65 *CDP Gain changing selection P S 0000
66 CDS Gain changing condition P S 10 (Note 2)
67 CDT Gain changing time constant P S 1 ms
68 For manufacturer setting 0
69 CMX2 Command pulse multiplying factor numerator 2 P 1
70 CMX3 Command pulse multiplying factor numerator 3 P 1
71 CMX4 Command pulse multiplying factor numerator 4 P 1
72 SC4 Internal speed command 4 S 200 r/min
73 SC5 Internal speed command 5 S 300 r/min
74 SC6 Internal speed command 6 S 500 r/min
75 SC7 Internal speed command 7 S 800 r/min
76 TL2 Internal torque limit 2 P S 100
77 100
78 10000
79 10
80 10
81 100
82 100
83 100
Expansion parameters 2
84
For manufacturer setting
0000
Note 1. Depends on the capacity of the servo amplifier.
2. Depends on the parameter No.65 setting.
www.DataSheet4U.com