7 Buffer Memory
7.4 Control Data
76
FX3U-1PG User's Manual
7.4.8 [BFM#56, #55] Operation speed change value
Set the operation speed change value that is used in the operation speed change function.
→ For details on the operation speed change function, refer to Section 6.6.
*1. In case of external command positioning operation
-2,147,483,647 to -1, 1 to 2,147,483,647 (user unit). Set the value within -200,000 to -1, 1 to 200,000
Hz when converted to pulse data.
7.4.9 [BFM#57] Operation command ΙΙ
A list of operation command II is as shown in the following table.
*1. Timing of detection.
Level detection: activated when the bit is set or cleared.
Edge detection: activated at OFF-to-ON transition.
Point
If INT0 (b0) or INT1 (b1) is on when the positioning operation starts, it automatically turns off.
BFM No.
Description R/W Default
High order
16bit
Low order
16bit
#56 #55
Setting range: 1 to 2,147,483,647 (user unit)
The value must be within the range from 1 to 200,000 Hz when converted to pulse
data.
*1
R/W K0
BFM No.
Bit
No.
Item Description
Detection
*1
Default
High order
16bit
Low order
16bit
-#57
b0 INT0
The interrupt input is executed via the PLC (BFM).
INT0 turns on when b0 = ON.
Edge
H0000
b1 INT1
The interrupt input is executed via the PLC (BFM).
INT1 turns on when b1 = ON.
Edge
b2 to
b15
- Not used - -
To Next Page
Loading...
