Mitsubishi Electric FX3U-1PG - 8 Manual Control; Functions Available with Manual Control

8 Manual Control
8.1 Functions Available with Manual Control
81
FX3U-1PG User's Manual
1
Introduction
2
Specification
3
System Configuration
4
Installation
5
Wiring
6
Before Starting Positioning Operation
7
Buffer Memory
8
Manual Control
9
Positioning Control
10
Program Example
8. Manual Control
This chapter explains manual control.
8.1 Functions Available with Manual Control
Manual operations and available functions are as shown in the following table.
: Applicable
- : Not applicable or not targeted
Functions
Operation mode
Reference
JOG operation
DOG type mechanical zero
return operation
Data-set type mechanical
zero return operation
High speed Creep
Extension positioning
parameter
Section 7.3
Forward limit/Reverse limit - Section 6.4
STOP command - Section 6.5
Remaining distance
operation
--- -
Subsection
6.5.2
Approximate S-shaped
acceleration/deceleration
- - - Section 6.8
Operation speed change
function
- - Section 6.6
Target address change
function
- - - - Section 6.7
Starting delay time - - - -
Subsection
7.4.1