Mitsubishi Electric FX3U-1PG - 9.4 2-speed Positioning Operation

9 Positioning Control
9.1 Functions Available with Each Positioning Operation
89
FX3U-1PG User's Manual
1
Introduction
2
Specification
3
System Configuration
4
Installation
5
Wiring
6
Before Starting Positioning Operation
7
Buffer Memory
8
Manual Control
9
Positioning Control
10
Program Example
9. Positioning Control
This chapter explains the control of each positioning operation.
9.1 Functions Available with Each Positioning Operation
Positioning operations and available functions are as shown in the following table.
: Applicable
- : Not applicable
Function
Operation mode
Reference
1-speed
positioning
operation
Interrupt
1-speed
positioning
operation
2-speed
positioning
operation
External
command
positioning
operation
Variable
speed
operation
Interrupt
stop
operation
Interrupt
2-speed
positioning
operation
Extension positioning
parameter
Section 7.3
Forward limit/Reverse
limit
Section 6.4
STOP command Section 6.5
Remaining distance
operation
----
Subsection
6.5.2
Approximate S-shaped
acceleration/deceleration
- - - - Section 6.8
Operation speed change
function
- Section 6.6
Target address change
function
- - Section 6.7
Starting delay time
Subsection
7.4.1