Mitsubishi Electric FX3U SERIES - List of Related Devices

FX 3S /FX 3G /FX 3GC /FX 3U /FX 3UC PLC User's Manual - Positioning Control Edition
Built-in Positioning Functions
10 Variable Speed Operation (Variable Speed Pulse Output) - PLSV Instruction
10.2 List of Related Devices
B - 144
Point:
• To use an FX
3U PLC of relay output type or triac output type, be sure to connect a high-speed output
special adapter.
• Differential line drive type outputs will be used for the outputs of the high-speed output special adapter.
2 : When a high-speed output special adapter is used as a destination for pulse output on a FX
3U PLC,
use the output shown in the following table for rotation direction signals.
When a built-in transistor output is used as a destination for pulse output on a FX
3S/FX3G/FX3GC/FX3U/
FX
3UC PLC, use transistor output for signals rotation direction.
3:D
.b is available only in FX3U and FX3UC PLCs. However, index modifiers (V and Z) are not available.
4 : Only available for FX
3G/FX3GC/FX3U and FX3UC PLCs.
5 : Only available for FX
3U and FX3UC PLCs.
10.2 List of Related Devices
1. Special auxiliary relays
The following table shows the related special auxiliary relays. Note that Y000, Y001, Y002, and Y003 are
devices that determine the pulse output destinations.
*1. Y002 is not available in FX3G PLC (14-point and 24-point type) and FX3S/FX3GC PLC.
*2. Y003 is available only when two high-speed output special adapters are connected to the FX
3U PLC.
*3. Only available for FX
3UC PLC Ver. 2.20 or later and FX3S/FX3G/FX3GC/FX3U PLC.
*4. Cleared when the PLC switches from RUN to STOP.
High-speed output special
adapter connection position
Pulse output Rotation direction output
1st adapter
= Y000
= Y004
= Y001
= Y005
2nd adapter
= Y002
= Y006
= Y003
= Y007
Device number
Function Attribute Refer to
Y000 Y001
Y002
*1
Y003
*2
M8329
"Instruction execution abnormal end"
flag
Read only Subsection 4.4.2
M8338
Acceleration/deceleration
*3,*4
Drivable Subsection 4.3.9
M8340 M8350 M8360 M8370
"Pulse output monitor" (BUSY/READY)
flag
Read only Subsection 4.4.3
M8343 M8353 M8363 M8373 Forward limit Drivable Subsection 4.3.1
M8344 M8354 M8364 M8374 Reverse limit Drivable Subsection 4.3.1
M8348 M8358 M8368 M8378 Positioning instruction activation Read only Subsection 4.4.4
D
1
D
2
D
1
D
2
D
1
D
2
D
1
D
2
Downloaded from ManualsNet.com search engine