Mitsubishi Electric FX3U SERIES - Special Function Unit;Block

1 Introduction
1.2 Introduction of Products Needed for Positioning
A - 7
FX 3S /FX 3G /FX 3GC /FX 3U /FX 3UC PLC User's Manual - Positioning Control Edition
Common Items
A
Common Items
B
Built-in Positioning Functions
Apx.
Example Connection
1.2.4 Special Function Unit/Block
Connect a special function unit/block to the FX3U/FX3UC PLC to control positioning operations. Note that a
special function unit can individually control positioning operations.
1. System configuration for FX3U PLC
Up to 8 special function units/blocks can be connected to the FX3U PLC.
For details on system configuration, refer to the FX
3U Hardware Edition.
2. System configuration for FX3UC PLC
Up to 8
*1
special function units/blocks can be connected to the FX3UC PLC.
FX
2NC-CNV-IF or FX3UC-1PS-5V is needed to connect special function units/blocks.
*1. Up to 7 special function units/blocks can be connected to the FX
3UC-32MT-LT(-2) PLC.
*2. The unit/block number begins with "No. 1" when special function unit/blocks are connected to the
FX
3UC-32MT-LT(-2) PLC.
For details on system configuration, refer to the FX
3UC Hardware Edition.
3. Individual operation (FX2N-10GM, FX2N-20GM)
Without connecting special function units (FX2N-10GM, FX2N-20GM) to the PLC, you can operate them
individually.
•FX
2N-10GM can control one 1-axis servo motor or stepping motor.
•FX
2N-20GM can control two 1-axis servo motors or stepping motors.
In addition, up to 48 I/O points can be added.
Special function block
Special function unit
No.0 No.7
to
Up to 8 units
FX 3U PLC
Servo motor
(Servo amplifier)
FX3UC PLC
FX3UC-1PS-5V
or
FX2NC-CNV-IF
Special function block
Special function unit
No.0 No.7
to
Up to 8 units
Servo motor
(Servo amplifier)
*2
Servo motor
(Servo amplifier)
2-axes
Servo motor
(Servo amplifier)
1-axis
Servo motor
(Servo amplifier)
1-axis
FX
2N
-10GM FX
2N
-20GM
Downloaded from ManualsNet.com search engine