Mitsubishi Electric FX3U SERIES - Fx 3 U Plc

FX 3S /FX 3G /FX 3GC /FX 3U /FX 3UC PLC User's Manual - Positioning Control Edition
Common Items
2 Unit Connection
2.4 FX3U PLC
A - 10
2.4 FX3U PLC
*1. The relay output and triac output type PLCs do not have pulse output.
*2. The product connects with the servo amplifier via the terminal block, MIL connector (20 pins), or the
SSCNET dedicated connector.
*3. FX
3U-20SSC-H only connects with the servo amplifier applicable to SSCNET III.
For details, refer to the FX
3U-20SSC-H USER'S MANUAL.
Note:
• For details on the connectable special function units/blocks and system configuration, refer to the following
manual.
Refer to the FX
3U Hardware Edition.
Up to 2 units can be
connected.
General-purpose output
of main unit
European terminal
board
FX
3U
PLC
A B
Special function block
Special function unit
MIL connector (20-pin)
*2
SSCNET III dedicated
connector
*2
Terminal board (M3)
*2
*1
B and show the unit positions.
(For details of installation, refer to the manuals of special adapter and
special function units/blocks.)
Transistor output (Y000 to Y002)
*1
Transistor output (Y000 to Y002)
A
FX 3U -2HSY-ADP
A
B
Up to 8 units can be
connected.
FX
2N
-10PG
f
B
f
A
START
DOG
X1
X0
POWER
ERROR
FP
PGO
RP
CLR
Servo motor
*3
or
Stepping motor
Terminal board (M3)
Downloaded from ManualsNet.com search engine