Mitsubishi Electric FX3U SERIES - Fx 3 Uc Plc

FX 3S /FX 3G /FX 3GC /FX 3U /FX 3UC PLC User's Manual - Positioning Control Edition
Common Items
2 Unit Connection
2.5 FX3UC PLC
A - 11
A
Common Items
B
Built-in Positioning Functions
Apx.
Example Connection
2.5 FX3UC PLC
*1. The relay output type PLCs do not have pulse output.
*2. The product connects with the servo amplifier via the terminal block, MIL connector (20 pins), or the
SSCNET dedicated connector.
*3. FX
3U-20SSC-H only connects with the servo amplifier applicable to SSCNET III.
For details, refer to the FX
3U-20SSC-H USER'S MANUAL.
*4. Up to 7 special function units/blocks can be connected to the FX
3UC-32MT-LT(-2) PLC.
Note:
• Use the FX
3UC-1PS-5V (extension power supply unit) only if the 5V DC power supply unit incorporated in
the FX
3UC PLC does not have enough capacity.
For details, Refer to the FX
3UC Hardware Edition.
• For details on the connectable special function units/blocks and system configuration, refer to the following
manual.
Refer to the FX
3UC Hardware Edition.
- Terminal board (M3)
*2
*1
- MIL connector (20-pin)
*2
- SSCNET III dedicated
connector
*2
MIL connector (20-pin)
FX3UC PLC
C
B
Up to 8
*4
units can be connected.
C
and show the unit positions.
(For installation details, refer to the manuals of special function units/blocks.)
Transistor output (Y000 to Y002)
B
FX3UC-1PS-5V
FX2NC-CNV-IF
General-purpose output of
main unit
C
C
Special function
block
Special function
unit
B
FX 2N -10PG
fB
f
A
START
DOG
X1
X0
POWER
ERROR
FP
PGO
RP
CLR
Servo motor
*3
or
Stepping motor
Downloaded from ManualsNet.com search engine