7 PARAMETER SETTINGS
7.3 Basic Setting
33
7
*1 First to third octet: first to third octet of the IP address of the master station
Fourth octet: automatically numbered from the number not in use from 1 to 254 in ascending order
• Automatic detection of connected device
Detects the connected slave stations and reflects to the network configurations setting.
In the network configuration setting, communication settings such as IP addresses and subnet masks can be configured for
the detected slave stations. Parameters that are inherent in the slave stations can also be read/written from/to the network
configuration setting. (Some slave stations do not support these features.) Various settings of all slave stations can be
configured in parameters of the master station (the settings do not need to be configured in each individual slave station) and
therefore the man-hour for the setting will be reduced.
RX/RY Setting Points Set the assignment of the number of points for RX/RY in increments of 64
points.
• 64 (1 Occupied Station)
• 128 (2 Occupied Station)
• 192 (3 Occupied Station)
• 256 (4 Occupied Station)
(Default: 64 (1 Occupied Station))
Start The start number of RX/RY is displayed.
End The end number of RX/RY is displayed.
RWw/RWr Setting Points The number of points for the number of stations in increments of 32 points is
displayed.
Start The start number of RWw/RWr is displayed.
End The end number of RWw/RWr is displayed.
Group No. Set group numbers of slave stations. 1 to 2
(Default: 1)
RSVD STA Set whether to set the slave station as a reserved station. • No Setting
• Reserved Station
(Default: No Setting)
IP Address Specify the IP address of the slave station. 0.0.0.1 to 223.255.255.254
(Default:
*1
)
Subnet Mask Specify the subnet mask of the slave station. 0.0.0.1 to 255.255.255.255
(Default: Subnet mask of the
master station)
MAC Address The MAC address of the slave station is displayed.
Comment The information entered in "Comment1" on the "Properties" window
displayed by right-clicking the module in the list of stations or the network
map is displayed.
Up to 32 one-byte characters/16
two-byte characters
(Default: Blank)
Item Description Setting range
To Next Page
Loading...
