Mitsubishi Electric MDS-B-SPJ2 Series User Manual (English)

Questions and Answers:

E
Erin WilsonAug 11, 2025
What to do if the Mitsubishi Electric Portable Generator orientation completed signal is not output?
- D
  Devin PettyAug 11, 2025
  If the orientation completed signal is not outputting from your Mitsubishi Electric Portable Generator, consider these potential solutions: * If 'Orientation is not carried out' check the troubleshooting for that problem. * If the machine load is heavy, reconsider the in-position range by adjusting parameter x OINP. * Also, reconsider the speed loop gain during orientation by adjusting parameters VGOP and VGOI.
R
Raymond AdamsAug 21, 2025
What to do if the spindle stops after passing the orientation stop on a Mitsubishi Electric Portable Generator?
- L
  Lauren WintersAug 21, 2025
  If the spindle on your Mitsubishi Electric Portable Generator stops after passing the orientation stop, or stops after swaying, consider these potential solutions: * Ensure that you correctly set the gear ratio parameters. * Readjust the parameter CSP and select the optimum value. * Readjust the parameters PGM and PGE and select the optimum value. * Set the orientation stop to PRE by changing SPECO to PRE.
N
nicole85Aug 31, 2025
What to do if the stop position deviates on a Mitsubishi Electric Portable Generator?
- B
  Bobby CookAug 31, 2025
  If the stop position deviates on your Mitsubishi Electric Portable Generator, it could be due to a machine factor. Try setting the deceleration ratio to 1:1 or 1:2. Also, noise could be a factor, so try using one encoder cable.

Mitsubishi Electric MDS-B-SPJ2 Series Specifications

General

Brand	Mitsubishi Electric
Model	MDS-B-SPJ2 Series
Category	Portable Generator
Language	English

Mitsubishi Electric MDS-B-SPJ2 Series User Manual

Table of Contents

Questions and Answers:

Mitsubishi Electric MDS-B-SPJ2 Series Specifications