Mitsubishi Electric MELDAS 600 Series User Manual

MITSUBISHI CNC
MELD/IS 600 Series
MAINTENANCE TOOL
INSTRUCTION MANUAL
BNP-63988-001* (ENq
ADVANCED AND EVER AOVANCING
Mll’SlJBlSHl ELECTRIC

Mitsubishi Electric MELDAS 600 Series Specifications

General

Brand	Mitsubishi Electric
Model	MELDAS 600 Series
Category	Power Tool
Language	English

Summary

3. Starting and Ending the M6 Maintenance Tool

3.1 Starting the tool

Procedures for powering on and initiating the maintenance tool.

3.2 Ending the tool

4. Memory Back Up

4.1 Preparation

4.2 Operating procedure

Detailed steps for performing memory backup using the tool.

4.3 Explanation of commands

Details commands for reading, writing, comparing, and clearing memory.

4.4 Error messages

Lists and explains error messages encountered during memory backup.

5. Serial Number and NC Type, Unit type Set

5.2 Operating procedure

Steps to set serial number, CNC type, and unit type.

6. Servo Spindle F/W Down Load

6.2 Starting the tool

Describes the two modes for starting the servo/spindle download.

6.3 Operating procedure in the normal mode

Details operational steps for the normal mode download.

6.3.2 Operation display

6.3.3 Error information

Classifies and explains CNC side and amplifier side errors.

6.4 Operating procedure in the automatic firmware download mode

6.4.1 Operation procedure

Steps for firmware download using automatic mode.

6.4.2 List of error Nos.

Details specific error numbers encountered in servo download.

7. Command Line Mode

7.5 Explanation of commands

7.5.4 Display memory

7.5.5 Modify memory

7.5.6 Write FROM

Command to write data to FROM memory.

7.5.7 Erase FROM

7.5.8 Copy memory

7.5.9 Write memory

7.5.10 Clear memory