8Perform Sequencer Direct
Operation flow 2-70
[Changing position display]
(a) Forward/ backward feed
Each time [F3] (Prev) or [F4] (Next) key is pushed, displayed position is changed.
The display changes as follows:
[F3] (Prev): From 1 to 999, 998, 997, ..., 1
[F4] (Next): From 1 to 2, 3, ..., 999, 1
(b) Call number
Push [FUNCTION] key, change the function key allocation, and push [F2] (NUMBER) key
to display the position number input screen below.
Input a position number and push [EXE] key to come back to the screen and display the tar-
get position.
When a number other than 1 to 999 is entered, the [EXE] key gets unavailable.
Push [F4] (CLOSE) key to come back to the previous screen.
[Displaying menu screen]
Push [FUNCTION] key, change the function key allocation, and push [F4] (CLOSE) key to
come back to the ENHANCED menu screen.
[Handling when T/B became invalid]
When T/B became invalid while displaying the sequencer direct teach screen (including the
teach confirmation and position number input screens), saves the position data and comes
back to the ENHANCED menu screen.
[Handling when entered into AUTOMATIC mode]
When changed to AUTOMATIC mode while displaying the sequencer direct teach screen
(including the teach confirmation and position number input screens), an error "H5000 TB
Enable key is ON " occurs and an error screen appears. The screen comes back to the previ-
ous screen by resetting the error.
<SQ DIRECT>
POSITION NUMBER ( )
123
⇒
CLOSE
To Next Page
Loading...
