3Installing the option devices
Installing the J1 axis operating range change (RV-4FR/7FR/13FR series)
3-63
3) Because to install the Mechanical Stopper screw, once move the J1 axis to the position of 0 degree. Turn
on the power supply and move the J1 axis by jog operation.
4) Install the <3> Mechanical Stopper screw. Install the <3> attached Mechanical Stopper screw to the needed
point with referring to Table 3-11 and Fig. 3-4.
<1>Stopper Block J1
+
<2>
Resin Stopper B
Mechanical Stopper screw B
Mechanical Stopper screw A
<1>Stopper Block J1
+
<2>
Resin Stopper B
Mechanical Stopper screw D
Mechanical Stopper screw C
(Back side)
To Next Page
Loading...
