Mitsubishi Electric Melsec A Series - Page 158

REPLACEMENT OF THE MELSECNET/10 (PLC TO PLC NETWORK)
4 - 17
4
(3) Parameter of standby station
*1
: Compatible, : Partial change required, ×: Incompatible
*1 Standby station is a station type of simple dual-structured system.
Only the following CPU modules support the simple dual-structured system.
• Process CPU
Parameter
name
Description
Compat-
ibility
Precautions for replacementQnA/QnAS series
MELSECNET/10 module
Q series
MELSECNET/H module
(MELSECNET/10 mode)
Network
parameter
Network type Network type
Starting I/O No. Starting I/O No.
Network No. Network No.
- Group No.
Set the group No. in GX Works2 or
GX Developer network parameters.
- Mode
Set the mode in GX Works2 or GX
Developer network parameters.
Standby station compatible
module
Standby station compatible
module
Routing parameters Routing parameters
Valid module during other
station access
Valid module during other
station access