Mitsubishi Electric MELSEC-F FX-USB-AW - 2. System Configuration and Connecting Procedure; 2.1 System Configuration

2 System Configuration and Connecting Procedure
2.1 System Configuration
8
FX-USB-AW/FX 3U -USB-BD USER'S MANUAL
USB Driver Installation Edition
2. System Configuration and Connecting Procedure
2.1 System Configuration
For details of the programming communication, refer to the following manual.
→ Refer to the FX Series User's Manual - Data Communication Edition
2.1.1 FX-USB-AW
*1. FX1NC Series PLC specification details for I/O, wiring, installation, and maintenance can only be found
in the Japanese Manual.
• Please refer to individual PLC manuals for PLCs not mentioned above.
2.1.2 FX3U-USB-BD
Connected equipment Baud rate Cable for personal computer connection
Programmable controller
FX0, FX0S, FX0N, FX1S 9.6 kbps
USB cable of 5m (196.9") at most
(Included cable is 3m (118.1"))
FX1N, FX1NC*
1
19.2 kbps or less
FX2N (Earlier than Ver. 3.00),
FX2NC(Earlier than Ver. 3.00)
9.6 kbps
FX2N (Ver. 3.00 or later),
FX2NC(Ver. 3.00 or later)
19.2 kbps or less
FX
3U, FX3UC 115.2 kbps or less
Positioning unit FX2N-10GM, FX2N-20GM 9.6 kbps
Programmable cam switch FX2N-1RM-E-SET 9.6 kbps
Connected equipment Baud rate Cable for personal computer connection
Programmable controller
FX3U
115.2 kbps or less
USB cable of 5m (196.9") at most
(Included cable is 3m (118.1"))
FX3UC-32MT-LT(-2)
- PLC
- Positioning unit
- Programmable cam switch
FX-USB-AW
Personal
computer
+
Connect to the
programming port
USB driver
software
Install
USB
port
USB cable for personal computer
connection (included with the product)
- PLC
+ FX
3U-USB-BD
Personal
computer
USB cable for personal computer
connection (included with the product)
USB driver
software
Install
USB
port