Mitsubishi Electric MELSEC-F FX3G Series - Installation of Main Unit

8 Installation In Enclosure
8.4 Procedures for Installing on and Detaching from DIN Rail
108
FX3G Series Programmable Controllers
User's Manual - Hardware Edition
8.4.2 Installation of main unit
The main unit must be installed before installing a special adapter or connector conversion adapter on the
enclosure.
→ For the connection procedure, refer to Subsection 8.6.3 and Subsection 8.6.4.
1 Push out all DIN rail mounting hooks (A in the
right figure).
2 Fit the upper edge of the DIN rail mounting
groove (B in the right figure) onto the DIN rail.
3 Lock the DIN rail mounting hooks (C in the following figure) while pressing
the PLC against the DIN rail.
1 1
A
B
B
CC
33