Learning to Use the FX Family for Positioning Control MELSEC FX PLC positioning
4 - 14
MITSUBISHI ELECTRIC
Click on the
Positioning
tab and then set Y000 (pulse output destination) as follows.
The "Bias speed" corresponds to the minimum speed.
Can only be set for a FX
3U
or FX
3UC
main unit.
Fig. 4-11:
"Positioning" window
Setting item Setting value
Bias speed [Hz]
500
Maximum speed [Hz] 100,000
Creep speed [Hz] 1000
Zero return speed [Hz] 50,000
Acceleration time [ms] 100
Deceleration time [ms] 100
Interrupt input for DVIT instruction
X000
Tab. 4-10:
Settings for Y000
To Next Page
Loading...
