Mitsubishi Electric MELSEC FX Series - Page 7

FX Positioning Control Systems I
Safety Guidelines
General safety information and precautions
For use by qualified staff only
This manual is only intended for use by properly trained and qualified electrical technicians who are
fully acquainted with the relevant automation technology safety standards. All work with the
hardware described, including system design, installation, configuration, maintenance, service and
testing of the equipment, may only be performed by trained electrical technicians with approved
qualifications who are fully acquainted with all the applicable automation technology safety
standards and regulations. Any operations or modifications to the hardware and/or software of our
products not specifically described in this manual may only be performed by authorised Mitsubishi
Electric staff.
Proper use of the products
The programmable logic controllers of the FX 1S , FX 1N , FX 2N, FX 2NC , FX 3G , FX 3GC , FX 3GE , FX 3S , FX 3U and
FX
3UC series are only intended for the specific applications explicitly described in this manual. All
parameters and settings specified in this manual must be observed. The products described have all
been designed, manufactured, tested and documented in strict compliance with the relevant safety
standards. Unqualified modification of the hardware or software or failure to observe the warnings on
the products and in this manual may result in serious personal injury and/or damage to property. Only
peripherals and expansion equipment specifically recommended and approved by Mitsubishi
Electric may be used with the programmable logic controllers of the MELSEC FX family.
All and any other uses or application of the products shall be deemed to be improper.
Relevant safety regulations
All safety and accident prevention regulations relevant to your specific application must be observed
in the system design, installation, configuration, maintenance, servicing and testing of these
products. The regulations listed below are particularly important in this regard. This list does not claim
to be complete, however; you are responsible for being familiar with and conforming to the
regulations applicable to you in your location.
● VDE Standards
– VDE 0100
Regulations for the erection of power installations with rated voltages below 1000 V
– VDE 0105
Operation of power installations
– VDE 0113
Electrical installations with electronic equipment
– VDE 0160
Electronic equipment for use in power installations
– VDE 0550/0551
Regulations for transformers
– VDE 0700
Safety of electrical appliances for household use and similar applications
– VDE 0860
Safety regulations for mains-powered electronic appliances and their accessories for house-
hold use and similar applications.