Mitsubishi Electric MELSEC iQ-F Series - Overview of CC-Link IE TSN

2 SERVO AMPLIFIER SETTING
2.1 Switch Setting and Display
12
2
2 SERVO AMPLIFIER SETTING
2.1 Switch Setting and Display
The IP address can be set with the rotary switches of the MR-JET-G. The communication status and alarm status of the
network can be checked with the LEDs.
* A protective film is attached on the front of the servo amplifier before shipment.
For details on the switch setting and the display of the MR-JET-G, refer to the following.
MR-JET-G User's Manual (Introduction) [3.2 Switch setting and display of the servo amplifier]
For details on the switch setting and the display of the MR-J5-G, refer to the following.
Page 60 Display
No. Name Description
[1] Display Indicates the servo status and an alarm number using one-digit, seven-segment LEDs.
[2] Rotary switches (SW1/SW2) Sets the IP address of the servo amplifier. (Page 14 Ethernet Parameter Settings)
[3] Servo status display LED
(SRV)
SON Off: Indicates Ready OFF and Servo OFF state.
Flashing: Indicates Ready ON and Servo OFF state.
On: Indicates Ready ON and Servo ON state.
[4] Network status display LED
(N/W)
RUN Off: Indicates that an alarm has occurred.
On: Indicates that the power is on.
ERR Off: Indicates that neither an alarm nor a warning has occurred.
Flashing: Indicates that a warning has occurred.
On: Indicates that an alarm has occurred.
LA A Indicates the link status for CN1A.
On: Link-up
LA B Indicates the link status for CN1B.
On: Link-up
[1]
[2]
[3]
[4]