Mitsubishi Electric MELSEC iQ-F Series - Cyclic Transmission

25
3 PROGRAMMABLE CONTROLLER SETTINGS
3.5 Parameter Settings
3.5 Parameter Settings
This section describes how to set parameters required for the programmable controller using GX Works3.
1. In the "Navigation" window of GX Works3, select [Parameter]  [FX5SCPU]  [Module Parameter]  [Ethernet Port].
If the "Navigation" window is not displayed, go to the menu bar, and select [View]  [Docking Window] 
[Navigation] to open the window.
2. Set an IP address and a subnet mask in "Own Node Settings" of "Basic Settings".
In this manual, the following setting values are used. (For the setting values, refer to  Page 11 System Configuration.)
An IP address is not set by default. When an IP address is not set, the CPU module operates with IP address
192.168.3.250.
Item Setting value
IP Address 192.168.3.250
Subnet Mask 255.255.255.0