Mitsubishi Electric MELSEC iQ-F Series - Page 35

3 PROGRAMMABLE CONTROLLER SETTINGS
3.6 Adding Structures and Global Labels
34
3
To set Data Type, click [...] and follow the step in the figure below.
2. Double-click "Detailed Setting" of "G_stLinkIEF" set in step 1. "Detailed Setting" is located in [Assign (Device/Label)]
column. Deselect [Use Bit Specification], set the device as shown below, and click [OK].
*1 Set the specified label name. (fixed)
*2 Set the data name of the structure you have specified before here. (Page 32 Addition of structures (labels))
Because the data type can be selected in "Data Type Selection", you do not need to input characters in this field.
*3 The field will be displayed by clicking [Detailed Setting].
*4 When [Detailed Setting] is selected, [Easy Display] is displayed.
*5 To input this value in the field, [Use Bit Specification] must be deselected.
Type Category Data Type
Structured Data Type stRemoteReg
Label Name Data Type Device
bnRX Bit (0..127) B0
*5
bnRY Bit (0..127) B80
*5
unRWr Word [Unsigned]/Bit String [16-bit] (0..63) W0
unRWw Word [Unsigned]/Bit String [16-bit] (0..63) W40
Double-click
Deselect it.