Mitsubishi Electric MELSEC iQ-F Series - Page 57

4 Replacement from FX3U to FX5UJ
4.3 Selection of Substitute Models
55
4
•FX5UJ
■Cable sizes for European type terminal block
Suitable wiring and tightening torque are described below.
■Differences and precautions regarding installing the FX3U and FX5UJ
The pitch of the holes for installation in a control panel and the width differ between the FX3U and FX5UJ. When making a
direct installation in a control panel, installation holes must be added. Also, because the terminal block shapes differ, one
terminal block cannot be replaced with the other. ( Page 54 External dimension drawing)
■Differences and precautions regarding the drive power supply of the output section of the
FX3U-16M and FX5UJ
• Output section power supply voltage consolidation
When replacing the FX3U-16M with the FX5UJ, the power supplies must be consolidated if a separate power supply has
been installed with the common terminal of the FX3U-16M.
• Maximum output load current
When the FX3U-16M is replaced with the FX5UJ, the maximum load current of the output section changes.
If separate power supplies have been installed with each common terminal, consolidate the power supplies.
External color: Munsell 0.6B7.6/0.2
Unit: mm
The terminal block uses M3 terminal
screws
35 mm width DIN rail can be installed
Model name W: mm W1: mm Weight: kg
FX5UJ-24M 95 76 Approx. 0.55
FX5UJ-40M 130 111 Approx. 0.65
FX5UJ-60M 175 156 Approx. 0.80
Wire size for
one wire
Wire size for
two wires
Wire ferrule with
insulation sleeve
(wire size)
Tightening
torque
Stripping dimensions of
electric wire ends
FX3U-485-BD, FX3U-485ADP(-MB) AWG22 to
AWG20
AWG22 AWG22 to AWG20 0.22 to 0.25
Nm
9 mm
FX5-485-BD, FX5-485ADP
FX5-4AD-ADP, FX5-4DA-ADP, FX5-
4A-ADP, FX5-4AD-PT-ADP, FX5-
4AD-TC-ADP
0.20 Nm
(Example) FX3U-16MT/ES (output side) (Example) FX5UJ-24MT/ES (output side)
<Number of outputs per common>
• 1 common terminal per output
<Maximum output load current>
• Maximum load (resistance load) current of 1 output common
terminal: 0.5 A or less
<Number of outputs per common>
• 1 common terminal per 3 or 4 outputs
<Maximum output load current>
• Maximum load (resistance load) current of 1 output common terminal:
0.5 A or less
• Maximum load (resistance load) current of 3 output common terminal:
0.6 A or less
• Maximum load (resistance load) current of 4 output common terminal:
0.8 A or less
15
82 (mounting hole pitch)
90
W
83
8
2-
φ
4.5-diam mounting hole
W1 (mounting hole pitch)
Y2Y0 Y1
COM 1 COM2COM0 COM3
Y3
COM4 COM5 COM6 COM7
Y5 Y6 Y7Y4
Y3Y0 Y2
Y1
COM1COM0
0V
24V Y4
Y5
COM2
Y10Y6
Y11Y7