Mitsubishi Electric MELSEC iQ-R Series - Batch Read (Command: 0613)

10 BUFFER MEMORY ACCESS
10.1 Buffer Memory
155
10
Batch read (command: 0613)
Read data from the buffer memory of the host station (supported device).
Message format
The following shows the message format of the request data and response data of the command.
■Request data
■Response data
The value read from the buffer memory is stored. The data order differs depending on the type of code, ASCII code or binary
code.
Page 154 Read data, write data
Data specified by request data
■Command
■Subcommand
■Start address
Specify the buffer memory start address to be read. (Page 153 Start address)
■Word length
Specify the word length of the buffer memory to be read. (Page 154 Word length)
Specification range: 1H to 1E0H (480)
Specify the access range within the range of buffer memory.
(Start address + Word length -1)  Buffer memory range
ASCII code Binary code
ASCII code Binary code
Command Subcommand Start address Word length
0
30H
6
36H
1
31H
3
33H
13 H 06 H
0
30H
0
30H
0
30H
0
30H
00 H 00 H