Mitsubishi Electric MELSEC iQ-R Series - Page 221

12 FILE CONTROL
12.4 File Check
219
12
Communication example (files for MELSEC iQ-R series)
Read the file No. in the following conditions.
• Drive No.: 4
• File No.: 6
The file name is as follows:
(1) LINE\LINE.CSV (13 characters)
■Data communication in ASCII code
(Request data)
In the figure (1), set the value of "ASCII code" in the table of "Value of code corresponds to character" in "File name".
(Response data)
■Data communication in binary code
(Request data)
In the figure (1), set the value of "Binary code" in the table of "Value of code corresponds to character" in "File name".
(Response data)
Item Value of code corresponds to character
File name LINE\LINE.CSV
UTF-16 004C 0049 004E 0045 005C 004C 0049 004E 0045 002E 0043 0053 0056
ASCII code 3030
3443
3030
3439
3030
3445
3030
3435
3030
3543
3030
3443
3030
3439
3030
3445
3030
3435
3030
3245
3030
3433
3030
3533
3030
3536
Binary code 4C00 4900 4E00 4500 5C00 4C00 4900 4E00 4500 2E00 4300 5300 5600
1811
31 H 38 H 31 H 31 H
0000
30 H 30 H 30 H 30 H
00400000
30 H 30 H 34 H 30 H 30 H 30 H 30 H 30 H
0004
30 H 30 H 30 H 34 H
000D
30 H 30 H 30 H 44 H
(1)
Subcommand Drive No. (Fixed value 2) Number of file name characters(Fixed value 1) File name
000
30 H 30 H 30 H
0
30 H
000
30 H 30 H 39 H
6
36 H
File No.
(1)
11 H 18 H 40 H 00 H 00 H 00 H 0D H 00 H 04 H 00 H 00 H 00 H 00 H 00 H
Subcommand
Drive
No.
Number of file name
characters
(Fixed value 1) (Fixed value 2)
File name
00 H 06 H 00 H 00 H
File No.