Mitsubishi Electric MELSEC iQ-R Series - Page 1299

11 PROCESS CONTROL INSTRUCTIONS
11.3 Control Operation Instructions
1297
11
■Local work memory
The system uses this area as a work area.
To start the control from the initial status, clear data by using a sequence program.
*1 The cycle counter value is rounded off to the nearest whole number.
■Execution cycle (T)
Set the execution cycle (T) in SD816 and SD817 in single-precision real number.
Operand: (d2)
Device Symbol Name Recommended range Data type Standard
value
Set by
+0  Last value input
(e1')
System
+1 Cycle counter
*1
+2 Number of data
blocks stored in
the dead time
table
+3
+4
Dead time table
1
+5
+6
Dead time table
2

+2SN+1
+2SN+2
Dead time table
SN