Mitsubishi Electric MELSEC iQ-R Series - Page 1337

11 PROCESS CONTROL INSTRUCTIONS
11.3 Control Operation Instructions
1335
11
Processing details
This instruction provides control output according to the SV and MV patterns.
The S.PGS instruction has the following three output types.
The following is the processing block diagram of the S.PGS instruction. (The numbers (1) to (5) in the diagram indicate the
order of the processing.)
Output type Description
Hold type Outputs data while holding the value of setting time 10 (SV10).
Return type Sets the set value (SV) to 0 and outputs the last value of the manipulated value (MV).
Cyclic type Processes based on the setting time 1 (SV1) to 10 (SV10) and then restarts processing from setting time 1 (SV1).
MV PGS
MV 5 , MV 6
MV 3 , MV 4
MV 7 , MV 8
MV 1 , MV 2
MV 9 , MV 10
SV 1 SV 2 SV 3 SV 4 SV 5 SV 6 SV 7 SV 8 SV 9 SV 10
SV
BW
MHA
SPA
PTNO
OR
MODE
MLA
BB1
(3)
(4)
(2)
(2)
BB2
BB3
(5)
MAN
MV, MV1 to MV16
SV, SV1 to SV16
ML, MH
MV
PGS TYPE
SV count-up
MV
PGS
operation
Loop stop
determination
Loop stop
processing
OFF (all bits)
OFF (all bits)
BW=Last value
RUN (SPA=0)
STOP (SPA=1)
Output