Mitsubishi Electric MELSEC iQ-R Series - Loop Selector

1338
11 PROCESS CONTROL INSTRUCTIONS
11.3 Control Operation Instructions
Loop selector
S.SEL
In automatic mode, outputs the value selected by the selection signal from the input data, and in manual mode, outputs the
manipulated value (MV) in the loop tag memory.
■Execution condition
Setting data
■Description, range, data type
■Applicable devices
Ladder ST
ENO:=S_SEL(EN,s1,s2,s3,d1,d2);
FBD/LD
Instruction Execution condition
S.SEL
Operand Description Range Data type
(s1) Input data 1 start device Refer to "Input data 1". Single-precision real
number
(d1) Block memory start device Refer to "Block memory". Word
(s2) Operation constant start device Refer to "Operation constant". Word
(d2) Loop tag memory start device Refer to "Loop tag memory". Word
(s3) Input data 2 start device Refer to "Input data 2". Single-precision real
number
EN Execution condition  Bit
ENO Execution result  Bit
Operand Bit Word Double word Indirect
specification
Constant Others
X, Y, M, L,
SM, F, B, SB,
FX, FY
J\ T, ST, C, D, W,
SD, SW, R, ZR,
RD
U\G, J\,
U3E\(H)G
Z LT, LST,
LC
LZ K, H E $
(s1)         
(d1)         
(s2)         
(d2)         
(s3)         
RnCPU
RnENCPU
RnSFCPU RnSFCPURnPCPURnPCPU
(Standard) (Safety)
(Redundant) (Process)
(s1) (d1) (d2)(s2) (s3)
EN ENO
d1
d2
s1
s2
s3