Mitsubishi Electric MELSEC iQ-R Series - Page 1581

17 CC-LINK IE CONTROLLER NETWORK INSTRUCTIONS
17.1 Remote RUN
1579
17
• The execution status and the completion status of the RRUN instruction can be checked with the completion device (d) and
the completion status indication device (d)+1.
• The following figure shows the RRUN instruction execution timing.
• If the J.RRUN, G.RRUN, or Z.RRUN is used to execute processing, processing of one time is successively followed by the
next processing while the start-up contact is on.
• If the JP.RRUN, GP.RRUN, or ZP.RRUN is used to execute processing, processing is executed once at the start-up contact
off-to-on rise.
• Completion device (d)
This device turns on during END processing of the scan where the RRUN instruction completes, and turns off during the next END processing.
• Completion status indication device (d)+1
This device turns on or off depending on the completion status of the RRUN instruction.
When completed normally: Unchanged from off.
When completed with an error: The device turns on during END processing of the scan where the RRUN instruction completes, and turns off during the next
END processing.
• When completed successfully
• When completed with an error
END0END0END0END0END0
OFF OFF
OFF
ON
ON
OFF
RRUN
END0END0END0
OFF
1 scan
Sequence scan
Start contact
Completion device (d)
Completion status
indication device (d)+1
Channel n
CPU module on
the own station
CPU module on
the target station
Network module
CC-Link IE
Controller
Network module
Remote RUN
Stopped Stopped
Sequence scan
END0END0END0END0END0
OFF
OFF
OFF
OFF
OFF
ON
ON
ON
OFF
RRUN
1 scan
Error code
Sequence scan
Start contact
Completion device (d)
Completion status
indication device (d)+1
Link dedicated
instructions processing
result CH1 (SW0030)
Channel n
Target station error
CPU module on
the own station
CC-Link IE
Controller
Network module