Mitsubishi Electric MELSEC iQ-R Series - Page 1601

17 CC-LINK IE CONTROLLER NETWORK INSTRUCTIONS
17.5 Setting the Station Number to Own Station
1599
17
Processing details
• The station number of the normal, or own, station specified by (U) is set. After station number setting, the completion device
specified by (d) turns on.
• The execution status and the completion status of the UINI instruction can be checked with the completion device (d) and
the completion status indication device (d)+1.
• The following figure shows the UINI instruction execution timing.
Operation error
• Completion device (d)
This device turns on during END processing of the scan where the UINI instruction completes, and turns off during the next END processing.
• Completion status indication device (d)+1
This device turns on or off depending on the completion status of the UINI instruction.
When completed successfully: The device remains off.
When completed with an error: The device turns on during END processing of the scan where the UINI instruction completes, and turns off during the next END
processing.
Error code
((S)+1)
Description
E000H to EFFFH  MELSEC iQ-R CC-Link IE Controller Network User's Manual (Application)
(s)
UINI
255→2
SW0042
CC-Link IE Controller
Network moduleCPU module
[Own station]
END0END0END0END0END0
OFF
OFF
OFF
OFF
OFF
ON
ON
ON
OFF
Sequence scan
UINI instruction
Start contact
Completion device (d)
1 scan
Completion of
the instruction
Completed successfully
Execution of the instruction
Completion status
indication device (d)+1
Completed with an error