Mitsubishi Electric MELSEC iQ-R Series - Reading Data from the Intelligent Device Station;Remote Device Station (32-Bit Address Specified)

1610
18 CC-LINK IE FIELD NETWORK INSTRUCTIONS
18.3 Reading Data from the Intelligent Device Station/Remote Device Station (32-bit Address Specified)
18.3 Reading Data from the Intelligent Device Station/
Remote Device Station (32-bit Address Specified)
JP.REMFRD
This instruction reads data from the buffer memory area of the intelligent device station or the remote device station (in units
of words, 32-bit address specified).
■Execution condition
• The RnCPU and RnENCPU with firmware version "22" or later support this instruction. (Use an engineering tool with version "1.025B" or later.)
• The RnPCPU (process) and the RnPCPU (redundant) with firmware version "04" or later support this instruction. (Use an engineering tool with version
"1.025B" or later.)
• The RnSFCPU (standard) with firmware version "06" or later supports this instruction. (Use an engineering tool with version "1.025B" or later.)
• The RJ71GF11-T2 and RJ71EN71 with firmware version "12" or later support this instruction. (Use an engineering tool with version "1.025B" or later.)
Ladder ST
ENO:=JP_REMFRD(EN,J,s1,s2,s3,s4,n,d1,d2);
FBD/LD
Instruction Execution condition
JP.REMFRD
RnCPU
RnENCPU
RnSFCPU RnSFCPURnPCPURnPCPU
(Standard) (Safety)
(Redundant) (Process)
(J) (s1) (s2) (s3) (s4) (d1) (n) (d2)
EN
J
ENO
s1
s2
d1
d2
s3
s4
n