Mitsubishi Electric MELSEC iQ-R Series - Page 1630

1628
18 CC-LINK IE FIELD NETWORK INSTRUCTIONS
18.6 Reading the Module Status Information of an Intelligent Device Station
*2 If a module or a unit does not support the information, a default value is stored.
*3 A value is stored only when the value stored in b15 of the 2nd word (Module access) is 1 (enabled). When the value stored in b15 of the
2nd word is 0 (disabled), a default value is stored.
*4 When a module is mounted on a slot and accessible, 1 is stored. When a module occupying two or more slots is mounted, a value is
stored only for a slot where a module is actually mounted.
*5 A value is stored only for a remote head module.
Operation error
3rd word b0 to b3 Module type
details
*3
0000:Not set (default)
0001:Remote head module
0010:Power supply module
0011:Base unit
0100:Input module
0101:Output module
0110:I/O combined module (different numbers)
0111:I/O combined module (same number)
1000:Intelligent function module
1111:Module or unit other than above

b4 to b7 Reserved Fixed to 0 
b8 Safety function
setting
*3
0: Invalid (default)
1: Valid

b9 Reserved Fixed to 0 
b10 Safety operation
status
*3
0: Not operating (default)
1: Operating

b11 Reserved Fixed to 0 
b12 Redundant function
setting
*3
0: Invalid (default)
1: Valid

*5
b13 Reserved Fixed to 0 
b14 to b15 Redundant
operation status
*3
00: Not operating (default)
01: Standby system
10: Control system

*5
4th word  Latest error code 0000:No error (default)
Other than 0000:Error code

Error code
((s)+1)
Description
D000H to DFFFH  MELSEC iQ-R CC-Link IE Field Network User's Manual (Application)
Device Bit Item Description Power
supply
module
Base
unit
Modules
mounted on the
CPU slot and
slot No.0 to
No.63