Mitsubishi Electric MELSEC iQ-R Series - Page 1754

1752
21 A/D CONVERSION INSTRUCTIONS
21.3 Restoring the User Range Setting Values
• For R60TD8-G
Operand: (s)
Device Item Description Setting range Set by
+0 System area 
+1 Completion status The instruction completion status is stored.
• 0: Completed successfully
• Other than 0: Completed with an error (error code)
 System
+2 System area 
+3 System area 
+4 CH1 Factory default setting offset value (L) System
+5 CH1 Factory default setting offset value (H) System
+6 CH1 Factory default setting gain value (L) System
+7 CH1 Factory default setting gain value (H) System
+8 CH1 User range setting offset value (L) System
+9 CH1 User range setting offset value (H) System
+10 CH1 User range setting gain value (L) System
+11 CH1 User range setting gain value (H) System
+12 CH1 User range setting
thermoelectromotive force offset value (L)
System
+13 CH1 User range setting
thermoelectromotive force offset value (H)
System
+14 CH1 User range setting
thermoelectromotive force gain value (L)
System
+15 CH1 User range setting
thermoelectromotive force gain value (H)
System
+16 CH2 Factory default setting offset value (L) System
+17 CH2 Factory default setting offset value (H) System
+18 CH2 Factory default setting gain value (L) System
+19 CH2 Factory default setting gain value (H) System
+20 CH2 User range setting offset value (L) System
+21 CH2 User range setting offset value (H) System
+22 CH2 User range setting gain value (L) System
+23 CH2 User range setting gain value (H) System
+24 CH2 User range setting
thermoelectromotive force offset value (L)
System
+25 CH2 User range setting
thermoelectromotive force offset value (H)
System
+26 CH2 User range setting
thermoelectromotive force gain value (L)
System
+27 CH2 User range setting
thermoelectromotive force gain value (H)
System
+28 CH3 Factory default setting offset value (L) System
+29 CH3 Factory default setting offset value (H) System
+30 CH3 Factory default setting gain value (L) System
+31 CH3 Factory default setting gain value (H) S
ystem
+32 CH3 User range setting offset value (L) System
+33 CH3 User range setting offset value (H) System
+34 CH3 User range setting gain value (L) System
+35 CH3 User range setting gain value (H) System
+36 CH3 User range setting
thermoelectromotive force offset value (L)
System
+37 CH3 User range setting
thermoelectromotive force offset value (H)
System
+38 CH3 User range setting
thermoelectromotive force gain value (L)
System
+39 CH3 User range setting
thermoelectromotive force gain value (H)
System