Mitsubishi Electric MELSEC iQ-R Series - Adding 32-Bit Binary Data

936
7 APPLICATION INSTRUCTIONS
7.20 Data Processing Instructions
Adding 32-bit binary data
DWSUM(P)(_U)
These instructions add the (n) points of 32-bit binary data in the devices starting from the specified one.
■Execution condition
Setting data
■Descriptions, ranges, and data types
*1 When specifying setting data by using a label, define an array to secure enough operation area and specify an element of the array
label.
■Applicable devices
Ladder ST ST
ENO:=DWSUM(EN,s,n,d);
ENO:=DWSUMP(EN,s,n,d);
ENO:=DWSUM_U(EN,s,n,d);
ENO:=DWSUMP_U(EN,s,n,d);
FBD/LD
Instruction Execution condition
DWSUM
DWSUM_U
DWSUMP
DWSUMP_U
Operand Description Range Data type Data type (label)
(s) DWSUM(P) Start device where the data for calculating the
total value are stored
 32-bit signed binary ANY32_S
*1
DWSUM(P)_U 32-bit unsigned binary ANY32_U
*1
(d) DWSUM(P) Start device for storing the total value  64-bit signed binary ANY32_ARRAY
(Number of elements: 2)
DWSUM(P)_U 64-bit unsigned binary
(n) Number of data 0 to 65535 16-bit unsigned binary ANY16
EN Execution condition  Bit BOOL
ENO Execution result  Bit BOOL
Operand Bit Word Double word Indirect
specification
Constant Others
X, Y, M, L,
SM, F, B, SB,
FX, FY
J\ T, ST, C, D, W,
SD, SW, FD, R,
ZR, RD
U\G, J\,
U3E\(H)G
Z LT, LST,
LC
LZ K, H E $
(s)         
(d)         
(n)         
RnCPU
RnENCPU
RnSFCPU RnSFCPURnPCPURnPCPU
(Standard) (Safety)
(Redundant) (Process)
(s) (d) (n)
EN ENO
sd
n