Mitsubishi Electric MELSEC iQ-R Series - File Register Operation Instructions; Switching the File Register Block Number

7 APPLICATION INSTRUCTIONS
7.22 File Register Operation Instructions
991
7
7.22 File Register Operation Instructions
Switching the file register block number
RSET(P)
These instructions change the block number of the file register used in the program.
■Execution condition
Setting data
■Description, range, data type
■Applicable devices
Ladder ST
ENO:=RSET(EN,s);
ENO:=RSETP(EN,s);
FBD/LD
Instruction Execution condition
RSET
RSETP
Operand Description Range Data type Data type (label)
(s) Block number data to be changed or the device number
where the block number data is stored
0 to 32767 16-bit signed binary ANY16
EN Execution condition  Bit BOOL
ENO Execution result  Bit BOOL
Operand Bit Word Double word Indirect
specification
Constant Others
X, Y, M, L,
SM, F, B, SB,
FX, FY
J\ T, ST, C, D, W,
SD, SW, FD, R,
ZR, RD
U\G, J\,
U3E\(H)G
Z LT, LST,
LC
LZ K, H E $
(s)         
RnCPU
RnENCPU
RnSFCPU RnSFCPURnPCPURnPCPU
(Standard) (Safety)
(Redundant) (Process)
(s)
EN ENO
s