Mitsubishi Electric MELSEC iQ-R Series - Page 162

160
APPX
Appendix 5 How to Use MELSEC-Q Series Modules
■ Interrupt pointer setting
"Interrupt Pointer Setting" of GX Works2 changes the following window in GX Works3.
The interrupt pointer setting method differs as below between GX Works2 and GX Works3.
• The SI No. setting of the interrupt module is not required on GX Works3.
• "Interrupt Pointer" of the interrupt module must be the serial number on GX Works3. (Set I51 on No.2 and I52 on No.3 when
No.1 is set I50.)
GX Works2 GX Works3
[Project window]  [Parameter]  [PLC Parameter] 
[PLC System]  [Interrupt Pointer Setting]
[Navigation window]  [Parameter]  [Module
Information]  Module model name  [Module
Parameter]