Mitsubishi Electric MELSEC iQ-R Series - Page 64

62
4 SYNCHRONOUS CONTROL STARTUP
4.4 Operation Check for Synchronous Control
2. Start and confirmation of the main shaft (input axis)
1. Set the axis No. for the main shaft (input axis). Double click X62 while pressing SHIFT.
2. Set the program No. for Axis 2. Double click X66 while pressing SHIFT.
3. Start the main shaft (input axis). Double click M80 while pressing SHIFT.
Output axes move while synchronizing to the movement of the main shaft.
1.
2.
3.