Mitsubishi Electric MELSEC iQ-R Series - Page 159

5 SAFETY APPLICATION CONFIGURATION EXAMPLES
5.2 System to Which Multiple Safety CPUs are Connected
157
5
■Application settings
Set the supplementary cyclic settings, safety communication settings, and other parameters of the CC-Link IE Field Network
master/local module. Display the application settings. Then, select and input parameters as shown below. Complete the input.
Then, click the [Apply] button in the lower right of the window. When setting "Safety Function Setting", double-click a line of
the safety function setting in item window, or click the right-side button to be displayed when selecting line.
Window
Displayed items
Setting classifications Safety programmable controller
(1)
CCIEF master (2-0)
Safety programmable
controller (2)
CCIEF master (3-0)
Safety programmable
controller (3)
CCIEF master (4-0)
Application
Settings
Supplementary Cyclic
Settings
Refer to Supplementary Cyclic Settings. Refer to Supplementary Cyclic
Settings.
Refer to Supplementary Cyclic
Settings.
Interrupt settings Do not set. Do not set. Do not set.
IP Address Do not set. Do not set. Do not set.
Communication mode Normal Normal Normal
Parameter name (Blank) (Blank) (Blank)
Dynamic Routing Enable Enable Enable
Event reception from
other stations
Enable Enable Enable
Module operation mode Online Online Online
Interlink transmission
settings
Do not set. Do not set. Do not set.
Setting of safety
communication use or
not
Use Use Use
Safety Communication
Setting
Refer to Safety Communication Setting. Refer to Safety Communication
Setting.
Refer to Safety Communication
Setting.