Mitsubishi Electric MELSEC iQ-R Series - Page 63

5 SAFETY APPLICATION CONFIGURATION EXAMPLES
5.1 System Configured by a Safety CPU
61
5
■Network configuration settings
Set the number of link device points and assignment of slave stations to the master station.
Operating procedure
1. Select a module from "Module List", and drag and drop it to the list of stations or the network map.
2. Select and input parameters as shown below.
3. Click "Close with Reflecting the Setting" to complete "Network Configuration Settings". If the window is closed using the
[] button, the settings are not reflected.
Window
Displayed items
Item Description
Assignment Method Number of points or Start number
Total number of slave stations 2
Item Range/value
CCIEF master (1) CCIEF remote (1) CCIEF remote (2)
Model RJ71GF11-T2 NZ2GFSS2-32D NZ2EXSS2-8TE NZ2GF2B1-16D
STA# 0 1 (Unavailable) 2
Station Type Master Station Remote device station (Unavailable) Remote device station
RX/RY (Unavailable) Points: 80
Start: 0000
End: 004F
(Unavailable) Points: 16
Start: 0050
End: 005F
RWr/RWw (Unavailable) Points: 16
Start: 0000
End: 000F
(Unavailable) Points: 20
Start: 0010
End: 0023
Reserved/Error Invalid Station No Setting No Setting (Unavailable) No Setting
Network synchronous
communication
Asynchronous Asynchronous Asynchronous Asynchronous
Station
information
Alias (Blank) (Blank) (Blank) (Blank)
Comment (Blank) (Blank) (Blank) (Blank)
List of
stations
Network map
Drag and drop a module.