Mitsubishi Electric MELSEC iQ-R Series - Page 640

638
37 EVENT LIST
37.2 Event List
*1 As for file-related events such as writing and deleting a file, the following files are targeted:
 Program file
 FB program file
 Parameter file
 Data logging setting file (common setting file, individual setting file)
*2 The engineering tool displays "Start-up information" in detailed information 1 only when the Process CPU with firmware version "06" or
later is used.
*3 Detailed information 2 is stored only when detailed information 1 is CPU module (3E00H).
25000 Operation Info Online module
change
The online module change
processing completed.
 System
configuration
information

25010 Online extension
cable change/
addition
Processing of the online extension
cable change/addition has
completed.
Extension cable
information

25200 System A/B setting
write
The system A/B setting was written
to the CPU modules.
Operation
source
information
System A/B
setting
information
26000 Redundant operation
mode change
(backup mode)
The operation mode in a redundant
system was changed to backup
mode.

26001 Redundant operation
mode change
(separate mode)
The operation mode in a redundant
system was changed to separate
mode.
2A200 Warning Memory
initialization
*1
The memory was initialized. Operation
source
information
Drive/file
information

2A201 Device/label zero
clear
Values in a device or label were
cleared to zero.
Device/label
information/
Device/label
clearing
information
2A202 Folder/file deletion
*1
A folder or file was deleted. Drive/file
information
2B000 System switching (by
a user)
The systems were switched due to
the cause on the user side.
System
switching
information
2B001 Memory copy
execution by the
engineering tool
(control system)
The memory copy function was
executed by the engineering tool.

2B002 Memory copy
execution by the
special relay and
special register
(control system)
The memory copy function was
executed by the special relay and
special register.

2B003 Memory copy
execution by a user
(standby system)
The memory copy function was
executed by a user.
2B004 Control system
forced start-up
One system was forcibly started as a
control system while waiting for a
start-up of the other system.
Operation
source
information
Control system
start-up cause
information
Event
code
Event
type
Event
category
Detected event Description Detailed information
1 2 3