Mitsubishi Electric MELSEC iQ-R Series - Page 676

674
APPX
Appendix 5 List of Special Register Areas
SD81 to
SD111
Detailed
information 1
Detailed information 1 (38) Tracking transfer trigger information
■SD81: With or without specification
b0: Block No.1 to 8
b1: Block No.9 to 16
b2: Block No.17 to 24
b3: Block No.25 to 32
b4: Block No.33 to 40
b5: Block No.41 to 48
b6: Block No.49 to 56
b7: Block No.57 to 64
■SD82 to SD85: Block number
(46) CPU module data backup/restoration folder information
■SD81: With or without specification
b0: Folder specification
b1: Date folder
b2: Number folder
■SD82: Folder specification
0: Specification allowed
1: Specification not allowed
■SD83 to SD84: Date folder (yyyymmdd)
Date of the folder is stored in BCD code. (yyyy: 0 to 9999, mm: 1 to
12, dd: 1 to 31)
FFFFFFFFH is stored when a folder cannot be specified.
• SD83: Lower word of the date folder (yyyymmdd)
• SD84: Upper word of the date folder (yyyymmdd)
■SD85: Number folder
0 to 32767 (FFFFH is stored when a folder cannot be specified.)
(58) Extension cable information
■SD81: With or without specification
b0: Base number
b1: Extension cable connector
■SD82: Base number
1 to 6: Extension level 1 to 6 (extension base units)
11: Main base unit (system A)
12: Main base unit (system B)
■SD83: Extension cable connector
0: OUT (Used when an error occurs in an extension cable between
either main base unit (system A/B) and the redundant extension
base unit, or between two extension base units (when the
extension base unit in the next upper level is one other than the
redundant extension base unit)
1: OUT1
2: OUT2
S (Error)
SD112 Detailed
information 2
information
category
Detailed information 2
information category code
Detailed information 2 information category code is stored.
• b0 to b7: Information category code
• b8 to b15: Unused (fixed to 0)
The following codes are stored into the information category code.
•0: N/A
• 2: Drive number and file name
• 3: Annunciator number
• 4: Parameter information
• 5: System configuration information
• 25: Process control instruction processing information
• 28: Program error information
S (Error)
No. Name Data stored Details Set by
(setting
timing)
b1b2b3b4b5b6b7
b0
16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1
b15 b14 b13 b12 b11 b10 b9 b8 b7 b6 b5 b4 b3 b2 b1 b0
32 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17
48 47 46 45 44 43 42 41 40 39 38 37 36 35 34 33
64 63 62 61 60 59 58 57 56 55 54 53 52 51 50 49
SD82
SD83
SD84
SD85
b1b2 b0
b1 b0
b15 b7b8
b0