Mitsubishi Electric MELSEC iQ-R - CSV File for Registration

APPX
Appendix 5 CSV File Format
275
A
CSV file for registration
If a value outside the range is set, the data in the corresponding row will not be added and overwritten to a BACnet module.
Column
No.
Column
comment
Description of data row Value to be set
1 to 38  The format is the same as the CSV file for engineering.
Page 274 CSV file for engineering
39 RAddress Start buffer memory address of an object Specify the value whose buffer memory address (word address) is
doubled (byte address) in decimal.
If "RWordAddress" is entered to the first column comment, the buffer
memory address will be handled as a word.
If the value is '0', a free space will be assigned automatically.
40 COVProcessID [9003]UnsolicitedCOV The sending of an UnsolicitedCOV is enabled.
0: No COV
1: Upon Value change only
2: Upon Value change and periodic COV transmission
3: Upon Value change and periodic COV transmission (When In
Alarm only)
41 COVInterval [9006]COVSendInterval This column is enabled only when '2' or '3' is set to the column No.40
(COVProcessID).
Set the send interval of a cyclic sending in seconds.
42 EventEnable [35]EventEnable 3-bit unsigned integer.
The bit corresponding to the event to be notified is '1'.
Set a value in decimal.
b2: Offnormal
b1: Fault
b0: Normal
43 LimitEnable [52]LimitEnable 3-bit unsigned integer.
The bit corresponding to the event to be notified is '1'.
Set a value in decimal.
b2: Change the upper/lower limit determination condition for power
factor (only for AnalogInput objects)
b1: HighLimit
b0: LowLimit
44 IntegerA 16-bit integer A Set values when converting the PresentValue property value of an
AnalogInput object, AnalogOutput object, or AnalogValue object.
16-bit integer A corresponds to "Real number A", and 16-bit integer B
corresponds to "Real number B".
If nothing is set, a real number will be assigned in 2 words.
45 RealA Real number A
46 IntegerB 16-bit integer B
47 RealB Real number B
48 Output [9004]ValueIsOutput 1: AnalogValue objects, BinaryValue objects, and MultistateValue
objects operate as their corresponding output objects.
Other than 1: AnalogValue objects, BinaryValue objects, and
MultistateValue objects operate as their corresponding input objects.
49 COVIncrement [22]COVIncrement Set the value of COVIncrement property.
50 TimeDelay [113]TimeDelay Set the value of TimeDelay property.